Ryobi P4003 Manuel D'utilisation page 10

NOTE: If the cable stops rotating, release the foot
pedal to avoid kinking or damaging the cable. Place
the direction of rotation selector in the clockwise (
position and try again. If the cable still does not rotate,
place the selector in the OFF position and push or pull
until the obstruction is dislodged.
NOTICE:
Do not run the drain auger in the clockwise (
tion for extended periods of time. Failure to follow these
instructions can result in damage to the tool.
 When the obstruction is cleared, place the direction of
rotation selector in the OFF position and slowly retract
the cable from the drain.
NOTE: If the tip of the cable is entangled and difficult to
remove, change the direction of rotation to clockwise (
and run the tool briefly to unwind and disengage from
the obstruction. Then slowly retract the cable by hand.
 Run water through your drain to confirm that the water
is flowing freely.
 After the cable has been properly cleaned, as described
in the next section, store the unit for later use.
OPERATION
CLEANING THE DRAIN AUGER
See Figure 10, page 14.
)
The drain auger should be cleaned after each use to prevent
contamination and residue build up.
To drain the drum:
 Remove the battery pack or power cord from the tool.
 Place the drum body in its highest angled position.
) posi-
 Lift the drain tab located on the back of the tool and allow
any liquids inside the drum to pour down a drain or into
a container approved for liquid waste.
To clean the cable:
 Remove the battery pack or power cord from the tool.
 Using a clean cloth and warm soapy water, pull the cable
out from the tool, cleaning it as it advances. Continue
)
until the cable has been fully advanced and completely
cleaned.
 Using a clean cloth moistened with lightweight machine
oil, push the cable back into the tool. Continue until the
cable has been fully retracted.
 To ensure that no water entered the tool, drain the drum
as described earlier.
10 — English