Teac UD-701N Mode D'emploi page 10

Connections (back) (continued)
Synchronizing external devices with
power operations of this unit
(trigger function)
The power of a connected preamp or another device that supports
trigger functions can be synchronized with the power operations of
this unit.
Use commercially-available mono mini plug cables for connections.
ATTENTION
To use the trigger function, set this unit's STANDBY/ON switch to ON.
UD-701N
10
12V TRIGGER connectors
OUT
When this unit is turned on, it outputs 12 V.
By connecting this unit's OUT connector to a device that supports
trigger input (e.g., a power amplifier or subwoofer), the power supply
of that device can be synchronized with the power operations of this
unit.
IN
Connect this to the trigger output connector of a preamp or other
device.
This will make the power operation of that preamp or other device
control this unit, putting it in standby and turning it on.
Device that supports trigger input
(e.g., AP-701 or power amplifier)
Mono mini plug cable
V
Complete all other connections before turning the
unit on.
o Carefully read the manuals of the devices that you are connecting
and follow their instructions when making connections.
o Do not bundle connecting cables with power cords. Doing so
could cause noise.
o Connect all plugs completely.