Teac UD-701N Mode D'emploi page 21

Changing the connected device
1
Press the SOURCE knob to show DEVICE SELECT.
The bottom line of the display shows the name of the last con-
nected device.
Display example
MENU
DEVICE SELECT
Player_1
Name of last connected device
2
Turn the SOURCE knob to show already paired
Bluetooth devices.
o The unit can remember a maximum of eight device pairings.
o If no paired device is available, the screen will appear as
follows.
MENU
DEVICE SELECT
NO PAIRED DEVICE
o Press and hold the ENTER button to enter pairing mode
(page 20).
o The first 16 characters of the device name are shown.
o If characters other than English letters and numbers are
included in the device name, it will not be shown properly.
3
Press the SOURCE knob to connect.
After connection, the display will show the input source.
ATTENTION
o Regardless of the connection status of this unit and the
other Bluetooth device, if the input source is not shown,
restart both this unit and the other device and then connect
them again.
o Depending on the Bluetooth device, you might also need to
conduct connection operations on it.
If you are unable to connect it successfully, refer to the
operation manual of the Bluetooth device.
4
Start playback on the other Bluetooth device.
Confirm that the volume is turned up on the other Bluetooth
device. If you do not turn up the volume on the playback
device, no sound might be output from this unit.
NOTE
Press and hold the MENU button to clear all pairings with other
Bluetooth devices.
EN
21