Installation - Sharp R-201W Mode D'emploi

1. Remove all packing materials from the inside of
the oven cavity. Discard the loose polythene sheet
from between the door and cavity. Remove the
feature sticker, if attached, from the outside of
the door.
Do not remove the protective film attached to the
inside of the door.
✓
REMOVE
ENERGY SAVE MODE:
Your oven comes pre-set for Energy Save Mode.
This facility saves electricity when the oven is not in use.
When you first plug it in, you cannot operate the oven until you open and close the oven door.
(The oven lamp will light while the door is open.)
In Energy Save Mode, if you do not operate the oven for 3 minutes or more (e.g. closing the door or at the end
of cooking), you will not be able to operate the oven until you open and close the oven door.
✗
DO NOT REMOVE

INSTALLATION

2. Check the oven carefully for any signs of
damage.
3. Place the oven on a flat, level surface strong
enough to support the oven's weight plus the
heaviest item likely to be cooked. Do not place
the oven in a cabinet.
4. Ensure there is a minimum free space above the
oven of 15cm:
5. Securely connect the plug of the oven to a
standard earthed (grounded) household electrical
outlet.
120
15cm