Calibrate The Touch Screen Pointer; Replace Worn Parts - HP Designjet T11 MFP Série Guide De Référence Rapide

Calibrate the touch screen pointer

1. Press the Setup tab.
2. Press the Options button.
3. Press the System button.
4. Press the Calibrate Touch Screen button and follow the instructions on the
screen.
Calibration is done by pressing the targets that appear in different positions on the
screen. Press the targets until they no longer appear.

Replace worn parts

Over time, the condition of certain key scanner parts will deteriorate. This section
addresses the parts that wear out under normal usage conditions and that can be
replaced without the assistance of an HP support technician.
To order any of the parts mentioned below, call HP Support.
Calibrate the touch screen pointer 49