Testing The Network Connection - Sartorius PMA.Vision VIS1X Notice D'installation

t
Select "Use the following IP address" (5).
t
Enter the IP address of the network connection (6).
t
Confirm your entry with "OK" and close the following
window with "OK".
4.2.2 Configuring Network on the Scale
t
Press the "i" button to call up the "Settings" menu.
t
Go into the submenu "Ethernet".
t
Go into the submenu "DHCP".
t
Select "Off".
t
Confirm with the "l" key.
y
The DHCP mode is now turned off.
t
Go into the submenu "IP (xxxxxxx)".
5
t
Select "t" to enter a new IP address.
6
t
Enter a new IP address using the input box.
Make sure:
− to use an IP address from the same address space as
the Windows PC (Subnet Mask).
− not to use the same IP address as the Windows PC.
t
Confirm the entry with the "l" button and exit the
settings.
The settings may have to be configured in the submenu
"Subnet Mask" and "Gateway".
t
Restart the scale.
t
Check the network connection (see Kapitel 4.3,
Seite 9).

4.3 Testing the Network Connection

The IP address and device ID can always be found in the
submenu "Device Information".
t
Press the "i" button to call up the "Settings" menu.
t
Go into the submenu "Device Information".
If the IP address of the scale changes, e.g. after the DHCP
server allocates a new address, an info message notifies the
user of the change:
English
Installation Instructions VIS1X 9