Fixing The Camera Bracket; Connecting The Camera; Pairing The Camera(S) - Extel WESV 82400 Guide D'installation Et D'utilisation

b. Installing the camera
Choose a suitable location to install the camera. As far as possible your system must be
installed in a dust-free place with weak vibrations and a good circulation of air and must be
equipped with a wall socket for the 5 VDC adaptor.
When installing the camera, check the good reception of the images on the monitor before
the final installation. For example ask another person to hold the camera in the area to
control. Ask another person to move the monitor to different places in the house to check
the good reception.
If you find some interference or other problems, please refer to the chapter "Maintenance".
c. Fixing the camera bracket
Make sure that no element interferes with the installation.
Search for a suitable place to fix the bracket.
Screw the wall part with the supplied screws (use bushing if necessary).
Screw the camera on the bracket A.
Aim the camera at the desired direction and tighten the side retaining screw B.
d. Connecting the camera
1. Connect the cord of the 5VDC adaptor to the "Power supply" plug of the camera.
2. Plug the adaptor into a 230 VAC outlet (the BATT indicator turns on).
3. Use without adaptor: Lithium battery with 4-hour battery life
Battery indicator: - Green LED: battery to be charged
e. Pairing the camera(s)
The camera supplied with the kit is already paired, each additional camera must also be
"associated" to the monitor.
If not, refer to the chapter 6-c "Associate the camera to the monitor".
6GB
A
- Red LED: empty battery
- LED OFF: full battery
CFI EXTEL WESV 82400 - 06/2009 - V1
B