Dip Switch Settings - LEGRAND Wattstopper W-100 Instructions D'installation

Table des Matières

Les langues disponibles

Sensor Adjustment

Remove the wall plate. Remove the button cap by firmly squeezing together the top sides of the button assembly. Gently pull it away

from the unit.

When the adjustments are completed, replace the button cap by inserting its hinges into the tabs on the main unit and then squeezing

the top of the button while pressing it into the unit. Reinstall the cover plate.

PW-200 shown.

PW-100 has a

single button.

Light Level Adjustment

The light level can be set with loads ON or OFF. To enable light level control and set the threshold: 1) Make sure the room is lit

appropriately. 2) Put the sensor into TEST mode (see Time Delay switches). You have 5 minutes to complete the procedure. 3) Press

and hold the ON/OFF button (Relay 1 button on the PW-200) for 3 seconds, until you hear a beep. 4) Step away from the sensor. After

25 seconds a beep sounds, indicating that the threshold level is set. This threshold is retained, even if power is lost, until it is re-set or

disabled. In the PW-200, light level control only affects Relay 2.

To disable light level control, press and hold the Relay 1 button for 7 seconds, until a double beep tone sounds.

Reset to Default

Use the DIP Switch Settings tables to return features to factory settings. To reset the PW, press and hold the Relay 1 button for 10

seconds, until a triple beep sounds. This resets the sensor and disables light level control (the brightest ambient light will not hold the

light OFF).

10 minutes

15 minutes

20 minutes

25 minutes

30 minutes

Walk-Through

Service bypasses occupancy

& light level functions. Control the

load manually using ON/OFF button.

Button

Hinges