Product Dimensions - Whirlpool IDC875SSS0 Instructions D'installation

■ The wall anti-tip bracket assembly (wall anti-tip brackets and
range anti-tip brackets) must be installed. To install the anti-
tip brackets shipped with the range, see "Install Range Anti-
Tip Brackets" and "Install Wall Anti-Tip Bracket" sections.
■ Grounded electrical supply is required. See "Electrical
Requirements" section.
■ Proper gas supply connection must be available. See "Gas
Supply Requirements" section.
■
Contact a qualified floor covering installer to check that the
floor covering can withstand at least 200°F (93°C).
■ Use an insulated pad or ¼" (0.64 cm) plywood under range if
installing range over carpeting.
IMPORTANT: To avoid damage to your cabinets, check with your
builder or cabinet supplier to make sure that the materials used
will not discolor, delaminate or sustain other damage. This oven
has been designed in accordance with the requirements of UL
and CSA International and complies with the maximum allowable
wood cabinet temperatures of 194° (90°C).
A
C
A. 35¹⁄₄" (89.5 cm)
B. Model/serial number plate
(located inside the oven
door on the right-hand side
oven door trim)

Product Dimensions

B
C. Adjustable legs 5³⁄₄" min. to 9¹⁄₁₆"
max. (14.6 cm min. to 23.0 cm max.)
D. 1" (2.5 cm)
E. 23⁵⁄₈" (60.0 cm)
Mobile Home - Additional Installation Requirements
The installation of this range must conform to the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280). When such standard is not
applicable, use the Standard for Manufactured Home
Installations, ANSI A225.1/NFPA 501A or with local codes.
In Canada, the installation of this range must conform with the
current standards CAN/CSA-A240-latest edition, or with local
codes.
Mobile home installations require:
■
When this range is installed in a mobile home, it must be
secured to the floor during transit. Any method of securing
the range is adequate as long as it conforms to the standards
listed above.
■ Four-wire power supply cord or cable must be used in a
mobile home installation. The appliance wiring will need to be
revised. See "Electrical Connection" section.
E
D
F
G
L
F. 29¹⁄₂" (75.0 cm)
G. 1⁵⁄₈" (4.0 cm)
H. Front panel
I. Oven door
H
I
C
K
J. 35¹⁄₄" to 37⁷⁄₈" max. (89.5 cm to 96.2 cm
max.)
K. 40⁹⁄₁₆" +/- ¹⁄₈" (103.0 cm +/- 2.5 mm)
L. 5³⁄₄" min. to 9¹⁄₁₆" max. (14.6 cm min. to
23.0 cm max.)
J
5