Gas Conversions; Lp Gas Conversion - Whirlpool IDC875SSS0 Instructions D'installation

Gas conversions from Natural gas to LP gas; or from LP gas to
Natural gas must be done by a qualified installer.
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 13" (33 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.

LP Gas Conversion

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect wall anti-tip brackets to wall behind range.
Connect range anti-tip brackets to underside of range.
Re-engage the anti-tip brackets, if the range is moved.
See the installation instructions for details.
Failure to follow these instructions can result in death
or serious burns to children and adults.
To Convert Gas Pressure Regulator
1. Turn manual shutoff valve to the "closed" position.

GAS CONVERSIONS

2. Unplug range or disconnect power.
3. Remove access cover from the gas pressure regulator.
Gas pressure regulator
4. Remove the access cap by using a wrench, turning the
5. Remove sprint retainer from the cap by pushing against the
6. Turn over the spring retainer so the "LP" is showing on the
7. Snap the spring retainer back into the cap.
8. Reinstall the cap onto the regulator.
A. Access cap
B. Gasket
C. Gas pressure regulator
A
A. To range
B. Manual shutoff valve "closed" position
C. Gas supply line
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
access cap counterclockwise.
flat side of the spring retainer. Look at the spring retainer to
locate the "NAT" or "LP" position.
bottom.
LP
D
E
B
C
A
A
B
C
D. Spring retainer LP position
E. Spring retainer NAT position
17