Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Gas conversions from Natural gas to LP gas or from LP gas to
Natural gas must be done by a qualified installer.
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
LP Gas Conversion
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti-tip bracket to rear range foot.
Reconnect the anti-tip bracket, if the range is moved.
Failure to follow these instructions can result in death
or serious burns to children and adults.
1. Turn the manual shutoff valve to the closed position.
A
A. To range
B. Manual shutoff valve "closed" position
C. Gas supply line
2. Unplug range or disconnect power.
12
GAS CONVERSIONS
To Convert Gas Pressure Regulator
1. Remove storage drawer or warming drawer. See "Replace
2. Locate gas pressure regulator at rear of storage or warming
3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with a
A
5. Turn over the gas pressure regulator cap and reinstall on
B
6. Replace plastic cover over gas pressure regulator cap.
C
To Convert Surface Burners
1. Remove burner cap.
2. Using a Phillips screwdriver, remove the burner base.
Oven Racks and Warming Drawer" section.
drawer compartment.
NOTE: On models with a warming drawer, an access cover
must be removed from the gas pressure regulator.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
⁵⁄₈" combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
F
B
F
C
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
F. Gas regulator shutoff valve (shown in the "open" position)
regulator so that the hollow end faces out and the marking
"<- LP" is facing the direction shown in the above drawing.
Side view before
D
E
Side view after
Publicité
Table des Matières
