Water Connection; Electrical Connection - Victoria Arduino EJ PRIMA Manuel D'instructions

1
2
3 3
4.2
WATER
CONNECTI ON
Avoid throttling in
connecting tubes.
that the drain pipe is able
to eliminate waste.
forbidden to use connecting
pipes already used in the
past. Filter maintenance
is the responsibility of the
purchaser.
Mesh filter
1
Softener
2
Drain 50 mm
3
Failing to maintain water into
the correct levels will void the
warranty.
WATER SPECIFICATIONS
• Total hardness 50-60 ppm
(parts per million).
• Water line
between 2 - 5 bar and
water to be cold.
the
Assess
• Min flow rate: 200 l/hr.
• Filtration level below 1.0
It is
micron.
• tds (total dissolved solids)
level between 50 – 250
ppm.
• Alkalinity level between 10
– 150 ppm.
• Chlorine level less than
0.50 mg/l.
• ph level between 6.0 - 8.0.
E AG L E O N E P R I M A | L I B R E T TO I ST R UZ I O N I - U S E R H A N D B O O K - M A N U E L D 'I N ST R U CTI O N S | 5 0
4.3
ELECTRI CAL
pressure
CONNECTI ON
Prior to connecting
machine to the electrical
mains, assess
voltage shown
machine's
corresponds with that of the
mains.
ELECTRICAL
SPECIFICATIONS
230V - monophase voltage
the
that the
on the
data plate