Prepa Rati On By The Pu Rchaser - Victoria Arduino EJ PRIMA Manuel D'instructions

IN FO RM ATION TO
THE USERS
Under the senses of the
Directives/Guidelines
2011/65/EU concern-
ing the reduction of the
use of dangerous sub-
stances in electric and
electronic equipment,
as well as the disposal
of wastes".
The symbol of
crossed large
bish container that is
present on the ma-
chine points out that
the product at the end
of its life cycle must be
collected separately
from the other wastes.
The user for this reason
will have to give the
equipment that got to
its life cycle to the suit-
able separate waste
collection centres of
electronic and elec-
tro-technical wastes,
or to give it back to the
seller or dealer when
buying a new equip-
ment of
type, in terms of one to
one.
The suitable separate
waste collection
the following sending
of the disused equip-
ment to recycling, the
dealing or
and compatible envi-
ronment disposal con-
tributes to avoid possi-
ble negative effects on
the environment and
on the people's health
and helps the recycling
of the materials the
machine is composed
the
of. The user's illegal
rub-
disposal of the product
implies the application
of administrative fines
as stated in Law Decree
n.22/1997" (article 50
and followings of the
Law Decree n.22/1997).
E AG L E O N E P R I M A | L I B R E T TO I ST R UZ I O N I - U S E R H A N D B O O K - M A N U E L D 'I N ST R U CTI O N S | 42
PREPA RATI ON BY
THE PU RCHASER
• Preparation of the in-
equivalent
stallation site.
The purchaser must
prepare the surface
on which the ma-
for
chine will stand suit-
able to support the
machine weight (see
the installation chap-
handling
ter).
• Electrical
ments.
The mains power in-
stallation must com-
ply with the safe-
ly regulations
standards
in the country of in-
stallation and must
include an efficient
earth system. An om-
nipolar cut-off device
must be installed on
the power line up-
stream of the ma-
chine.
The power wires must
be sized according to
the maximum current
required by the ma-
chine to ensure a total
voltage loss under full
load of less than 2%.
• Plumbing
ments.
Prepare
drain and a mains that
supply water a maxi-
mum hardness of 3/5
French degrees (60/85
ppm).
require-
and
in force
require-
a suitable