RDI AVALON Instructions Pour L'installation page 2

Need a little help installing your railing?
www.rdirail.com/support/installation-videos.html
GATE KIT
Warning: Always wear safety goggles.
All steps in these assembly instructions should be completed on a clean, non-abrasive
surface. Steps and procedures in these assembly instructions assume the use of the
included Boerboel ® Gate Hardware Kit (hinges and latch).
GATE KIT COMPONENT LIST:
Check the kit to ensure all components are included.
A
B
E
C
D
F
G
Read all instructions prior to installing product.
Refer to local building codes for installation requirements; failure to install this product in
accordance with building codes may affect safety of the product and void product warranty.
Refer to manufacturers safety instructions when operating any tools.
2
A) 2½" x 2½" x 36" or 42" Aluminum
Uprights – 2
B) Telescoping Metal Support Brace – 2
C) Allen Wrench for Hinges – 1
D) 1" Phillips Screws (for hinges) – 8
E) Hinges – 2
F) Gravity Latch – 1
G) 1" Phillips Screws (for latch) – 6
H) #8 x ³/ " Screws (For metal braces) – 4
8
H
I) #8 x ¾" Screws (For metal braces) – 4
I
J) #10 x 1" Screws – 4
J
TOOLS NEEDED:
– Safety Goggles
– Tape Measure
– Level
– Hacksaw or Chopsaw
– Rubber Mallet
– Drill
– Drill Bits
– #2 Square Drive Bit
– Spacer Blocks