VINCENT SA-94 Manuel D'utilisation page 31

CONNECTION OF A RECORDING DEVICE
If you want, you can use the RCA sockets "REC OUTPUT" (8) on the back of the appliance to connect an
analogue stereo recording device (e.g. CD recorder, cassette recorder etc.) or another appliance that is
intended to receive the unchanged, fixed stereo output level (line level) from the signal source selected on
the amplifier at any given time. The output level is independent of the VOLUME level, the channel BALAN-
CE and the GAIN function. The input signals at the XLR connectors can not be obtained at the recording
output (8) and thus can not be used as a source for recordings. Please note that while the preamplifier is
muted (2)(12) the recording output is switched off.
RCA connection
SA-94
Recording device,
e.g. tape recorder
LINE IN
Connect this signal output to the signal input ("LINE IN", "TAPE IN" or "REC IN") on the recording appli-
ance using RCA cables. Please note that some recording equipment can have a slightly detrimental effect
on the audio signal quality. Some recording devices have rather low input impedance, which can slight-
ly alter the input signal voltage. For maximal music enjoyment we recommend that you connect to the
"REC" terminal only for as long as the recording is actually being made.
CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and fre-
quency can be read on the back of the device beside the socket for the mains. If the electricity supply is
appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the
back of the device (11). Connect the other end of the mains cable to a mains socket.
Vincent
31