VINCENT SA-94 Manuel D'utilisation page 26

7
7. INPUT: Terminal for stereo audio
signals of the source equipment
Here you find six stereo inputs for source equip-
ment (5x RCA, 1x XLR) with analogue stereo (line
level) audio output.
8. REC OUTPUT: Output connectors
assigned to a recording device
If desired, you can connect a recording device
like a CD recorder or a tape recorder to this out-
put. The stereo signal of this output is identical to
the output signal of the selected audio source at
one of the preamplifier INPUTs and it is indepen-
dent of VOLUME control, BALANCE setting and
GAIN function. The signal from the XLR source is
not available at the recording output! As long as
the preamplifier is muted (2)(12), the "REC OUT-
PUT" does not give the music signal.
Vincent
26
REAR VIEW
8 9
9. OUTPUT: preamplifier outputs
(1xXLR, 2xRCA)
With these three pairs of connectors you can con-
nect the preamplified stereo audio signal of the
currently selected source to the power amplifier
channels. All RCA and XLR outputs may be used
at the same time. The VOLUME, BALANCE,
MUTE and GAIN settings have effect on the
signal at this output.
10. POWER CONTROL: ON/OFF control
These jack connectors (3.5 mm) provide the
on/off signal for the standby control (12V
Trigger).
11. Power Connector with Fuse holder
To establish the power supply, connect the plugs
of the power cable to the device and to a suitab-
le wall outlet. The small plastic housing holds the
fuse. Refer to the security precautions.
10 11