KIKKA BOO PYJAMA PARTY Mode D'emploi page 4

WARNINGS
• Read the instructions carefully before use and keep them for future reference. The child may be hurt if you do not follow these
instructions.
• This product is available both on one level and two levels. Depending on your purchase please follow the instruction for one level or te
instruction for two levels.
• Never hang anything up on the playpen.
• Secure four rails complete stretch for safe usage.
• Never put anything in the bed to prevent the child creeping.
• Suitable for baby under 14kgs in weight and 86.4cm in height.
• Attend the child at any time.
• Keep away from heat i.e burner, electric cooker.
• Prohibit using once destroyed.
I. THE METHOD TO OPEN:
1. Take out the playpen from carrybag.
2. Release the mattress and open it.
3. Open the sides until to be locked in position.
4. Push the oor centre down until it is completely at and stable.
II. THE METHOD TO FOLD:
1.Take out the mattress and pull the centre band up to higher.
2. Release the button up on rails centre, make it droop as "U", pull the centre band upmore. If not be completely droopy, then press again.
Secure the bulge fully up, push four legs together..
3. Wrap it in mattress and clip tightly.
4. Put the whole wrap in the carry bag for travel.
III. THE USAGE OF SECOND LAYER (ADDITIONAL PURCHASE)
1. Fit the tubes together.
2.Take o the mattress.
3. Place the mattress support inside the cot, ensuring that all the hooks are hooked over the top rails, and place the mattress inside the
support.
IV. CLEANING
Fabric parts:
1. The fabrics of the product must be cleaned with warm water and mild soap. After cleaning let the crib get completely dry before you
use it. If is absolutely forbidden to fold it and store it before it is completely dry.
2. Do not use strong cleaning agents, bleach or agents with abrasive particles, in order to clean the product. It is forbidden to clean it in a
washing machine, dryer, dry cleaning, bleach and tumble-dry it.
Plastic and metal parts:
1. The plastic and metal parts must be cleaned with a damp soft cloth and dried with dry soft cloth.
2. Do not let the product exposed to the harmful effect of external factors - direct sunlight, rain, snow or wind. This may lead to damage
of the metal and plastic parts and fading of the fabrics of the crib.
3. When you are not using the product, store it at a dry and well ventilated place, not in dusty, humid premises with very high or very low
room temperatures.
Frame: The frame can be repainted if necessary. Use only non-toxic paints approved for children' s goods. From time to time check all
plastic parts that are hanged on the frame. Tighten all screw and bolts if necessary.
ENGLISH