System Settings; Loader Setup - Quicke Q-Companion BT Notice Originale

2.3. System settings

2.3.1. Loader setup

The loader min- and max positions are normally configured at first start-up, through the product setup wizard and should not
need to be reconfigured. But should the need arise, for example due to new sensors mounted or refitted, the loader can be
reconfigured.
The loader is recalibrated in the Settings view, by selecting Loader setup. This will start a wizard that will guide you through
the calibration procedure. Performing the loader setup will not require recalibration of the implements.
Loader setup
Set loader to lowest position and
hold until round indicator turns green
min
1. Hold the loader against the
mechanical stop with full joystick
deflection until indicator turns
green (3-4 s). Confirm with check
mark.
Loader setup
Setup ready!
4. Press check mark to confirm.
Loader setup
Set loader to highest position and
hold until round indicator turns green
max
2. Hold the loader against the
mechanical stop with full joystick
deflection until indicator turns
green (3-4 s). Confirm with check
mark.
Fig.18 Loader setup
19
Loader setup
Set tool carrier to max dump position
and confirm to proceed
3. Control the tool carrier to
mechanical stop and confirm
with check mark.
Setup