Implement Configuration; Add Implement - Quicke Q-Companion BT Notice Originale

Setup

2.2. Implement configuration

Some configurations are specific to the active implement.Each implement needs to be calibrated, because the weight, geometry
and level position of implements vary. Also the weight lifted with different implements can vary. By having you calibrate each
implement separately, the accuracy of results produced by Q-companion is improved.
Configuration of implements is done in the Implements view. From that menu you can:
- Add an implement
- Select an implement
- Configure an implements level position
- Calibrate implement for load weighing
- Rename implement
- Delete an implement
Implements
fork / cal.a
balegrip / cal.b
bucket / gravel
New implement

2.2.1. Add implement

To add a new implement, go to Implement view, select New implement and press confirm. The new implement will be added to
the list.
Implements
fork / cal.a
balegrip / cal.b
bucket / gravel
New implement
Fig.8 Implement configuration
Fig.9 Add implement
12
bucket
Select
Calibrate level position
Weighing calibrations
Edit name
Delete
Implements
fork / cal.a
balegrip / cal.b
bucket / gravel
implement1
New implement