Select Implement; Rename Implement - Quicke Q-Companion BT Notice Originale

2.2.2. Select implement

Active implement is changed in the Implement view.
When working with Q-companion, it is important to switch the active implement (in the display) when you are changing the
implement fitted on the front loader. Selecting the implement in the display activates the correct calibrations, allowing the
implement position view and weighing view to show correct information.
Implements
fork / cal.a
balegrip / cal.b
bucket / gravel
New implement
1. Select which implement to activate.

2.2.3. Rename implement

The name of an implement can be changed to make it easier to distinguish between different implements and their intended
usage.
Implements
fork / cal.a
balegrip / cal.b
bucket / gravel
New implement
1. Select which implement to
configure.
2. Select Select and press confirm.
Fig.10 Select implement
bucket
Select
Calibrate level position
Weighing calibrations
Edit name
Delete
2. Select Edit name and confirm
by pressing the check mark.
Fig.11 Rename implement
13
bucket
Select
Calibrate level position
Weighing calibrations
Edit name
Delete
bucket
Edit name
bucket
2 _
3. Change name by pressing up or
down and right or left. Confirm
name by pressing right when on
the last character.
Setup