Adjustments
The P6245 has two internal controls: offset zero and offset range.
These controls rarely need to be adjusted, and only should be
changed after a probe calibration and functional check has been
performed on the oscilloscope.
In order to make adjustments to the probe, the compensation box top
cover needs to be removed with the optional release tool. Refer to
page 4- - 14. Use the optional adjustment tool for making any
adjustments.
Adjustment Locations
Refer to Figure 4- - 4 for the location of the offset zero and offset
range controls.
Offset Range
Adjust
Figure 4- 4: P6245 Adjustment Locations
P6245 Instruction Manual
EEPROM
Offset Amp
Offset Zero
Adjust
4- 9