Sony WRR-805A/CE62 Mode D'emploi page 7

B BATT (battery) indication
Displays the status of the batteries of this unit.
See "Battery indication" on page 7.
C RF (radio frequency) indications
The dot indications show the RF input level. Depending on
the RF input level, the number of dots changes as below.
Four dots on: more than 45 dBµ
Three dots on: between 35 dBµ and 45 dBµ
Two dots on: between 25 dBµ and 35 dBµ
One dot on: between 15 dBµ and 25 dBµ
No dot: less than 15 dBµ
D GP/CH (group/channel) indication
Shows the reception channel group and respective channel
number.
Each time you press the MODE button the group/channel
indication changes to the frequency and accumulated time
indications as shown below.
Group/channel indication
Accumulated time indication
Display example for WRR-805A/CE62 model
Frequency indication
In Accumulated time indication, it displays the accumulated
time of battery use (in one-minute increments).
See "Settings" on page 8.
4 SET button
Press to change and set the contents of the item on the
display.
See "Settings" on page 8.
5 MODE button
Press to select the item to be set on the display.
See "Settings" on page 8.
6 POWER switch
Turns the power of the tuner ON or OFF.
7 RF (radio frequency) indicator
Indicates the strength of the RF input signal.
On in green: more than 25 dBµ
On in red: between 15 dBµ and 25 dBµ
Off: less than 15 dBµ (less than muting level)
8 TX BATT (transmitter battery) indicator
Indicates the battery condition of the wireless microphone
transmitter. The indicator starts flashing about one hour
before the transmitter batteries go flat.
5
(GB)