Selecting Drum Sets On A Gs Sound Module - Roland ED PC-300 Mode D'emploi

PC-300
[Example]
Selecting Variation 8, instrument 3 (Piano
3w) on an SC-8850:
1. Set the MIDI transmit channel to
match that of the Part or module you
wish to control.
2. Press MIDI/SELECT [3] (the LED will
light).
3. Press the black G#4 key ("H") [9].
4. Press the "8" key in the NUMERIC
ENTRY section [12].
5. Press ENTER [14].
6. Press the black F#4 key ("L") [9].
7. Press the "0" key in the NUMERIC
ENTRY section [12].
Note: "L" corresponds to CC32. This Bank
Select message is sometimes used for selecting
other sound module modes. If so, several "L"
values are supported. See the module's manual
for details.
8. Press ENTER [14].
9. Press the black A#4 key ("Program
Change") [10].
10. Press the "3" key in the NUMERIC
ENTRY section [12].
11. Press ENTER [14].
12. Press MIDI/SELECT [3] again (the
LED will go out).
Selecting Drum Sets on a GS
sound module
The Drum Part (MIDI channel 10) of a
GS module does not respond to Bank
Select messages. However, if you try to
send only a Program Change message
from the PC-300, a Bank Select message
will end up being transmitted along with
it anyway because the data for the last
sound specified will have been retained in
memory. For this reason, you should
always send the value "0" for "H" and "L",
12
followed by the Program Number in order
to make sure you obtain the Drum Set you
need.
Note: "L" corresponds to CC32. This Bank
Select message is sometimes used for selecting
other sound module modes. If so, several "L"
values are supported. See the module's manual
for details.
[Procedure]
1. Set the MIDI transmit channel to 10.
See page 11.
2. Press MIDI/SELECT [3] (the LED will
light).
3. Press the black G#4 key ("H") [9].
4. Press the "0" key (C#5) in the NUMER-
IC ENTRY section [12].
Note: Press the [CANCEL] key [13] to erase
these values and start again.
5. Press ENTER [14].
6. Press the black F#4 key ("L") [9].
7. Press the "0" key (C#5) in the NUMER-
IC ENTRY section [12].
8. Press ENTER [14].
9. Press the black A#4 key ("Program
Change") [10].
10. Select the program number by press-
ing the appropriate keys in the NUMERIC
ENTRY section [12].
Example: to select the PC #49 Drum Set
(ORCHESTRA Set) on an SC-8850, Press
the "4" and then the "9" key.
11. Press ENTER [14].
12. Press MIDI/SELECT [3] again (the
LED will go out).