Roland ED PC-300 Mode D'emploi page 11

Computer connected using the serial connector on the sound module
1. Connect the PC-300's MIDI OUT port to the MIDI IN connector on the sound module
you wish to control.
Computer
2. Set the PC-300's KEYBOARD/PC switch to "KEYBOARD". See page 8.
Computer connected via the MIDI IN connector on the sound module
1. Connect the PC-300's MIDI OUT port to the MIDI IN connector on the MIDI process-
ing unit (MPU series, sound card, or the like).
Computer
2. Set the PC-300's KEYBOARD/PC switch to "KEYBOARD". See page 8.
Note: This setup requires that you activate the sequencer program's MIDI Thru/Soft Thru/MIDI
Echo function.
RS-232C connector
Computer cable
COMPUTER
connector
PC-300
COMPUTER switch
(set to MIDI)
MIDI OUT
connector
MIDI IN connector
PC 300
COMPUTER switch
(set to PC-2)
Sound module
MIDI IN
connector
MIDI OUT connector
Sound module
MIDI IN
connector
MIDI OUT connector
Owner's Manual
9