Bosch PLR 50 C Notice Originale page 37

OBJ_BUCH-2326-003.book Page 37 Thursday, August 20, 2015 8:43 AM
Continuous Measurement (Tracking) / Minimum/Maximum Measurement
(see figure D)
For continuous measurements, the measuring tool can be moved relative to the tar-
get, whereby the measuring value is updated approx. every 0.5 seconds. In this man-
ner, as an example, you can move a certain distance away from a wall, while the actual
distance can always be read.
Press the k button and select the button for continuous measurement
measuring button 1 to start the continuous measurement.
The minimum measurement is used to determine the shortest distance from a fixed
reference point. It is used, as an example, for determining plumb lines or horizontal
partitions.
The maximum measurement is used to determine the greatest distance from a fixed
reference point. It is used, as an example, for determining diagonals.
Continuous measurement automatically switches off after 4 mins. The last measured
value remains on the display.
List of the Last Measured Values/Calculations
The measuring tool stores the last 10 measured values and their calculations and dis-
plays them in reverse order (most recent measured value/most recent calculation
first).
Press the i button and select the p button.
Deleting Measured Values in the Measured-Value List
Press the i button and select the p button.
After selecting the h button, you can delete either the entire
measured-value list or individual measured values. Press the but-
ton h to delete the selected individual measured value.
Data Transmission to other Devices
The measuring tool is equipped with a Bluetooth® module, which enables data trans-
mission via radio technology to certain mobile terminals/devices with a Bluetooth® in-
terface (e.g., smartphones, tablets).
Bosch Power Tools
English | 37
. Press the
1 609 92A 1F3 | (20.8.15)