Explanation Of General View; Operating Instructions; Installing Or Removing Battery Cartridge; Charging - Dolmar AS-1212 Instructions D'emploi

Explanation of general view

1 Button
2 Battery cartridge
3 Charging light
4 Battery charger
5 Screw
6 Sprocket guard
7 Hex wrench
8 Bolt
9 Guide bar
10 Cutter
11 Revolving direction
12 Sprocket
13 Chain tension adjusting spring
15 Chain oil
16 Saw chain
1
2
12
17 Lock-off button
18 Switch trigger
19 Scabbard (chain cover)
20 Battery cover
21 Tip guard
22 Cutting force pushes chain saw toward operator.
23 Front face of housing
24 Cutting force pulls chain saw away from operator.
25 Shallow undercut
26 Finish cut from top
27 Chain saw will be pinched.
28 Branch will splinter.
29 Screwdriver
30 Spike

OPERATING INSTRUCTIONS

Installing or removing battery cartridge (Fig. 1)
- Always switch off the tool before insertion or removal of the
battery cartridge.
- To remove the battery cartridge, withdraw it from the tool
while pressing the buttons on both sides of the cartridge.
- To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip it
into place. Always insert it all the way until it locks in place
with a little click. If not, it may accidentally fall out of the tool,
causing injury to you or someone around you.
- Do not use force when inserting the battery cartridge. If the
cartridge does not slide in easily, it is not being inserted
correctly.
Charging (Fig. 2)
- The saw is delivered with the battery uncharged. Before
using the saw, the battery must be charged using the LG-
124 fast charger.
- Plug the battery charger into the proper AC voltage source.
The charging light will flash in green color. Insert the battery
cartridge so that the plus and minus terminals on the battery
cartridge are on the same sides as their respective markings
on the battery charger. Insert the cartridge fully into the port
so that it rests on the charger port floor. When the battery
cartridge is inserted, the charging light color will change
from green to red and charging will begin. The charging
light will remain lit steadily during charging. When charging
is completed in approx. 45 minutes, the charging light color
will change from red to green. After charging, unplug the
charger from the power source.
Battery type
Capacity (Ah)
Number of cells
AP-123
2,0
10