Setting The Display Brightness; Activating/Deactivating Bluetooth - Beurer WL 50 Mode D'emploi

4. To set the volume, press and hold the
5. To switch the radio off, press the Mode button until the time appears on the display.
Note
To improve reception, insert the AUX cable into the AUX connection on the rear of the device.
The AUX cable functions as an antenna.

7.7 Setting the display brightness

The device has three display brightness levels.
• To set the display brightness, press the Display button.
100% -> 50% -> display off

7.8 Activating/deactivating Bluetooth

To play your own music on the wake up light via Bluetooth
To activate Bluetooth
1. Press the Mode button. BLUE appears in the display, and
2. The wake up light can now be connected with other devices (e.g. smartphone) via Blue-
tooth . Once a device is connected to the wake up light via Bluetooth
®
will sound on the wake up light, and the Bluetooth
has been disconnected, the acoustic signal on the wake up light will sound again and the
Bluetooth symbol
®
on the wake up light, proceed as follows:
®
goes out.
or the button.
®
, you must first activate Bluetooth
®
starts to flash.
symbol
®
42
, an acoustic signal
®
will light up. If Bluetooth
.
®
®