Connecting The Gas Supply; Positioning The Logs; Fitting The Glass Panel - Dru ESTATE 02 Instructions D'installation Et Mode D'emploi

NB: the maximum length of horizontal pipe must
not be exceeded.
Fig. 4 illustrates how to calculate the total lengths of pipe.

Connecting the Gas Supply

With the appliance a 40 cm flexible stainless steel gas
hose with G3/8" nipple joint has been supplied to
facilitate quick and easy installation. An approved
connecting tap with coupling should be used in the supply
hose (In Belgium this must be B.G.V. approved).
Furthermore:
• Expel all air from the supply pipes/hoses before coupling
to the appliance.
• Do not turn the coupling tap when connecting it to the
gas supply.
• Avoid any pressure on the control tap and pipes.
• Check that all connections are gastight.

Positioning the logs

Position the logs as follows:
• Lay the large log against the back wall.
• Fill the burner with vermiculite.
• Spread it evenly (in a thin layer) on the burner tray and
the surrounding tray.
• Make sure that no vermiculite gets on or into the pilot
light burner, as this could prevent it from working
properly.
INSTRUCTIONS FOR INSTALLATION
• Sprinkle the chips on top of the vermiculite, on the tray
surrounding the burner tray.
Do not put any chips on the burner tray.
• Now lay the rest of the logs in place as illustrated in fig. 7.
The logs should not be laid in any other way as this could
cause the formation of soot. Neither should the logs
touch pilot light burner.
Do not use any materials other than those supplied.The
supplied materials are incombustible and have been
manufactured specifically for this appliance.

Fitting the glass panel

Once the logs are in position, the glass can be replaced.
Fit the pane into the edge at the bottom and fix with the
mounting strip at the top.
If the glass is broken or at all damaged it should be
replaced immediately.
fig. 7
13
Chips
Vermiculite
Estate / Castello