Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS FOR INSTALLATION
Foreword
Dear Customer,
We would like to thank you for buying this DRU product.
Our products have been designed and produced to meet
the highest possible quality, performance and safety
requirements, allowing you to enjoy years of problem-free
use.
The heater has an enclosed combustion chamber. Its
natural draught draws in the combustion air from outside
through a combined inlet-outlet system.The same natural
draught expels the combustion gasses.
In this booklet you will find instructions for the installation
and use of your new appliance. Please read these
instructions and the manual carefully to familiarize yourself
with the appliance. If you require any further support,
please do not hesitate to contact your supplier.
Unpacking
When unpacking the interior, be careful not to allow the
box of logs fall out of the combustion chamber.The glass
front is packed separately. Once the heater has been
unpacked, all packaging should be disposed of in the
regular manner.
Connection
This appliance should be connected by a competent person.
Mantel iron
70x50x4
Packing
INSTRUCTIONS FOR INSTALLATION
Type of gas
This appliance is suitable for G20 or G25. Please check
that the type of gas and the local pressure correspond
with the specifications on the data badge. All regulations
regarding gas installation, including any local regulations,
must be observed at all times. The appliance is to be
installed by a registered installer.
Important
• Keep curtains and any other flammable materials at least
50cm away form the appliance.
• Caution! Touching the heater when hot can cause burns
and blisters!
• The appliance should be installed and maintained by a
competent person.
• Do not install any so-called dust filter on or under the
casing.
• Do not hang wet clothes and towels etc. on the heater to
dry.
Positioning the appliance
The fire is designed to be built into a new fireplace of
incombustible and heat-resistant material.
Allow enough space for the depth of the appliance (400
mm) and work accurately, allowing for the narrow flange
on the inside. See figs. 1 and 2 for the build-in dimensions.
N.B.: this fire is not suitable for snug, hole-in-the-wall
installation.
38c-1067
fig. 3
10
Publicité
Chapitres
