Ac Voltage Measurement - Velleman DVM895 Mode D'emploi

9.9 TEMPERATURE
range
°C
NiCr-NiSi sensor
Overload protection: F0.5 A/600 V fuse
10. Operation
10.1 DC VOLTAGE MEASUREMENT
Do not measure circuits that may contain voltages > 600 VDC or
> 600 VAC
Use extreme caution when measuring voltages higher than 60 VDC
or 30 VAC rms.
Always place your fingers behind the protective edges of the test
probes while measuring!
Set the rotary switch in the desired "
1.
Connect the red test lead to the "VHz" jack and the black lead to the
2.
"COM" jack.
3. Connect the test leads to the source being measured.
4. Read the voltage value and the polarity of the red test lead on the LCD
display.
Notes
•
If the range is not known beforehand, set the selector switch to a high
range and lower gradually.
•
An over-range is indicated by 1 or -1. Set to a higher range.
•
The maximum input current is 600 V rms.

10.2 AC VOLTAGE MEASUREMENT

Do not measure circuits that may contain voltages > 600 VDC or
> 600 VAC
Use extreme caution when measuring voltages higher than 60 VDC
or 30 VAC rms.
Always place your fingers behind the protective edges of the test
probes while measuring!
Set the rotary switch in the desired "
1.
Connect the red test lead to the "VHz" jack and the black lead to the
2.
"COM" jack.
V. 03 – 09/11/2021
DVM895
accuracy
-50 to 150 °C
150 to 800 °C
± (3 °C + 1 digit)
± (3 % + 1 digit)
" position.
" position.
12
resolution
1 °C
©Velleman Group nv