Battery Test; Voltage Measurement - Velleman DVM811 Mode D'emploi

9.5 DIODE AND CONTINUITY
range
Overload protection: F0.5 A/500 V fuse

9.6 BATTERY TEST

range
current
1.5 V 50 mA
9 V
10. Operation

10.1 VOLTAGE MEASUREMENT

Do not measure circuits that may contain voltages > 500 VDC or
> 500 VAC
Use extreme caution when measuring voltages higher than 60 VDC
or 30 VAC rms.
Always place your fingers behind the protective edges of the test
probes while measuring!
1. Set the rotary switch in the desired V= or V~ position.
2. Connect the test leads to the source being measured.
3. Read the voltage value and the polarity of the red test lead on the LCD
display.
Notes
• If the range is not known beforehand, set the selector switch to a high
range and lower gradually.
• An over-range is indicated by 1 or -1. Set to a higher range.
V. 02 – 09/06/2020
Do not conduct diode or continuity measurements on
description
display reads the
approximate forward
voltage of the diode
built-in buzzer sounds
if resistance < 50 Ω
load
resolution
10 mV
5 mA 10 mV
DVM811
live circuits
forward DC current ± 10 µA
reversed DC voltage ± 1.8 V
open-circuit voltage ± 1.8 V
± (5.0 % rdg + 5 digits)
10
test condition
accuracy
©Velleman nv