Power Tool Use And Care; Service; Safety Instructions For Nibblers; Original Accessories/Auxiliary Equipment - Parkside PMK 550 A1 Traduction Des Instructions D'origine

4 . Power tool use and care

a) Do not force the power tool. Use the correct
power tool for your application. The correct
power tool will do the job better and safer at
the rate for which it was designed .
b) Do not use the power tool if the switch
does not turn it on and off. Any power tool
that cannot be controlled with the switch is
dangerous and must be repaired .
c) Disconnect the plug from the power source
and/or remove the battery pack, if detach-
able, from the power tool before making any
adjustments, changing accessories, or storing
power tools. Such preventive safety measures
reduce the risk of starting the power tool acci-
dentally .
d) Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users .
e) Maintain power tools and accessories. Check
for misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools .
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control .
g) Use the power tool, accessories and tool bits
etc., in accordance with these instructions,
taking into account the working conditions
and the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation .
h) Keep handles and grasping surfaces dry,
clean and free from oil and grease. Slippery
handles and grasping surfaces do not allow
for safe handling and control of the tool in
unexpected situations .
PMK 550 A1

5 . Service

a) Have your power tool serviced by a qualified
repair person using only identical replace-
ment parts. This will ensure that the safety of
the power tool is maintained .

Safety instructions for nibblers

■ Hold the tool with a firm grip .
■ Secure the workpiece properly .
■ Keep hands away from rotating parts .
■ The edges and chips from the workpiece are
sharp . Wear gloves . To prevent injuries, it is
also advisable to wear shoes with thick soles .
■ Do not place the tool onto the chips from
the workpiece . Otherwise the tool may be
damaged and malfunction .
■ Do not leave the tool running unattended .
Use the tool only when held in your hands .
■ Always ensure that you have a firm footing .
When you are working in an elevated position,
ensure that no-one is standing beneath you .
■ Avoid touching the grooved pin, the die or
the workpiece immediately after machining,
because the parts will still be very hot and can
cause skin burns .
■ Avoid cutting electrical cables . This can lead to
serious accidents due to electric shock .
Original accessories/auxiliary
equipment
■ Only use the accessories and additional
equipment that are specified in the operating
instructions and compatible with the appliance .
GB │ IE │ 5 ■