EdilKamin BIG Installation, Usage Et Maintenance page 17

3
75
150
140
139
150
130
27
22
62
29
62
2 screws
n°2 viti
150
DETAIL. X
Part. "X"
29
28
150
139
fig. 12
9
4
62
150
9
150
fig. 1
62
DETAIL. Z
"
Part. "Z"
62
bushings
24
screw
vite
fig. 2
*
fig. 4
150
140
COVERING INSTALLATION BIG/VIP
139
*
27
62
150
29
139
62
150
COVERING INSTALLATION LUX
23
139 139
139
150
43
62
22
62
22
62
2 screws
n°2 viti
23 DETAIL. X
24
Part. "X"
fig. 3
28
ASSEMBLING THE CERAMIC TOP BIG/VIP (fig. 13)
28
• Insert the 4 ceramics (*) spacers into their 4 free holes in the
cast iron top and place the ceramic top (28)
• if necessary, insert a washer between the silicone spacer
and the cast iron top.
NOTE:
• the red enamel with crystalline, applied to the majolica,
crazes (cracks) evenly over the whole surface. Crazing is not
a defect but is a characteristic of enamel applied to majolica
known as "craclè".
• The ceramic parts (majolica) are cast and enamelled
manually and may present small defects that will not
fig. 13
affect their quality (small dents or enamel porosity), but instead
testifies to their manual manufacture.
INCLUDED HARDWARE:
2 M6x25 screws
2 M6x12 screws
139 139
4 silicone spacers for ceramic top
8 flat washers diam. 6
22
2 bushings
150
The stove comes furnished with its lateral metal side
panels already assembled, while its ceramic upper and
lower front panels (22) and top (28) must be assembled
as follows:
22
ASSEMBLING THE UPPER FRONT PANEL (fig. 1-2)
• Position the ceramic upper front panel (22) so that it rests
against the front panel support (23) positioned above the door.
• Use an Allen key to fasten the front panel in place using
the 2 supplied M6x25 screws (the door must be opened before
performing this operation).
62
NOTE:
For correct assembly of the upper front panel (22), place the
n°2 viti
bushing supplied between the same and the front panel (23), as
shown in detail "Z" in Illustr. 2.
Part. "X"
ASSEMBLING THE LOWER FRONT PANEL (fig. 1-3)
• Use the supplied Allen key to loosen the screws that hold
the cast iron lower front grill (43) in place and remove it.
• Position the front panel (22) and use an Allen key to
fasten it in place using the 2 supplied M6x25 screws as indica-
ted in detail "X" (fig. 3).
ASSEMBLING THE CERAMIC TOP (fig. 4)
• Insert the 4 ceramics (*) spacers into their 4 free holes in the
cast iron top and place the ceramic top (28)
• Where necessary, affix the supplied washer between the sili-
cone spacer and cast iron top.
- 17
-