SEVERIN KA 4811 Mode D'emploi page 12

environments.
∙ Do not leave the appliance unattended
while connected.
∙ Caution: Any misuse can cause
severe personal injury.
In case of a defective appliance
A defective appliance can cause material
damage and injury:
∙ Check the appliance for damage
before every use. Do not operate if the
appliance shows any sign of damage.
∙ In the event that you detect damage,
please contact our customer service
department by phone or email (see
appendix).
∙ Repairs to this appliance or its power
cord must only be carried out by our
customer service.
Technical specifi cations
Device category, Automatic coffee maker with
Art. no. grinder
KA 4811
Voltage 220-240 V~, 50/60 Hz
Output 680 - 820 W
Dimensions 170 x 395 x 310 mm
(W x H x D)
Weight 3,5 kg
Special markings
Do not dispose of in domestic
garbage
This product complies with all
binding CE labelling directives.
On/Off button
Grinding for 2 cups
Grinding for 4 cups
Grinding for 6 cups
Mild coffee
Normal coffee
Using ground coffee
............ Grinding level; fi ne to coarse
12
Overview and parts included
1. Grinding regulator
2. Bean container
3. Water container, removable (at the rear)
4. Swing-out fi lter
5. Filter insert with drip-stop
6. Glass carafe
7. Hot-plate
8. Rating label (on underside)
9. Power cord with plug
10. Filter ring
11. Permanent fi lter
Measuring spoon (not shown)
Control panel
12. Button for ground coffee
13. Normal coffee button
14. Mild coffee button
15. On/Off switch
16. 2, 4 or 6 cup grinding selection
Automatic switch-off
The control panel display will switch off automatically about
35 minutes after the brewing cycle has been completed, or,
if no coffee is made, 60 seconds after the last input. The
appliance goes then into stand-by mode. Press any button
to return to the ready-mode.
Before using for the fi rst time
∙ Unpack the appliance completely and remove all
packaging materials and stickers.
∙ Clean the glass carafe, water container, fi lter, ring and
bean container lid as described in the section Cleaning
and care.
∙ Clean the bean container as described in the section
Cleaning and care.
∙ Before making coffee for the fi rst time, let the appliance
go through two or three fi ltration cycles using the
indicated maximum amount of cold water, but without
using ground coffee (see Cleaning and care / Flushing
the unit).
∙ This should also be done if the appliance has not been
used for an extended period of time, and after descaling.
Making coffee - General information
∙ A measuring scale on the water container allows the
container to be fi lled with the correct amount of clean
water. The left scale is used for standard-sized cups of
approx.125ml, while the right scale is used for smaller
cups.
∙ Make sure that the indicated maximum amount of water
is not exceeded.
∙ If several consecutive brewing cycles are required,
switch off the coffee maker after each cycle and let the
appliance cool down for approx. 5 minutes.
∙ Important note: When fi lling the appliance with fresh