Transport; Maintenance And Service; Maintenance And Cleaning - Bosch GCO 2000 Professional Notice Originale

OBJ_BUCH-1063-002.book Page 27 Tuesday, August 24, 2010 10:05 AM
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Workpiece Form
110 x 110
180 x 85
130 x 130
Minimal workpiece sizes
(= all workpieces that can be clamped via the
clamping spindle 8):
Length 80 mm
Cutting capacity, max. (0°/0°): 125 mm
Cutting Metal
– Set the desired mitre angle.
– Firmly clamp the workpiece as appropriate
for its dimensions.
– Switch on the machine.
– Slowly guide the tool arm downward with the
handle 3.
– Cut the workpiece applying uniform feed.
– Switch the machine off and wait until the cut-
ting disc comes to a complete stop.
– Guide the tool arm slowly upward.
Adjusting the Depth Stop (see figure H)
In the delivery condition of the machine, the
depth stop 16 is adjusted in such a manner that
a new 355 mm cutting disc does not touch the
base plate when cutting.
To compensate the wear of the cutting disc, the
depth stop can be set deeper.
Bosch Power Tools
When using a new cutting disc, the depth stop
must then always be set back to the original po-
sition.
Mitre/Bevel Angle
0° 45°
125 Ø 100 Ø
– Bring the power tool into the working posi-
– Loosen lock nut 25 with the supplied ring
82 x 82
– Swing the tool arm with the handle 3 to the
– Screw the depth stop 16 in clockwise or an-
90 x 75
– Slowly guide the tool arm upward and tight-
75 x 75

Transport

– Always carry the power tool by its transport

Maintenance and Service

Maintenance and Cleaning

Always adjust the depth stop in such a man-
ner that the cutting disc does not touch the
base plate when cutting.
tion. (see "Releasing the Machine (Working
Position)", page 25)
spanner 14 (13 mm).
requested position.
ticlockwise direction until the screw head
touches the housing.
en the lock nut 25.
handle 18.
The power tool should always be carried by
two persons in order to avoid back injuries.
When transporting the power tool, use only
the transport devices and never use the
protective devices.
Before any work on the machine itself, pull
the mains plug.
Clean the ventilation slots of your power
tool regularly with a soft brush. The motor
fan draws dust into the housing, and a large
accumulation of metal dust can lead to elec-
trical hazards.
In extreme conditions, always use dust ex-
traction as far as possible. Blow out ventila-
tion slots frequently and install a residual
current device (RCD). When working metals,
conductive dust can settle in the interior of
the power tool. The total insulation of the
power tool can be impaired.
1 609 929 U62 | (8/24/10)
English | 27