Elinchrom Ranger Quadra AS Manuel D'utilisation page 11

Radio Remote Control EL-Skyport / Remote Control & Synchronisation (10)
The integrated EL-Skyport Transceiver offers:
• Wireless flash triggering / synchronisation
• Wireless control of the flash power setting
• Wireless on/off control of the LED Pilotlight
• Programmable 4 Groups
• Programmable 8 Frequency channels, to prevent interference with other wireless systems.
To activate and use these functions, the optional EL-Skyport Transmitter 19351 is required.
EL-Skyport Status LED
LED off: The EL-Skyport wireless system is deactivated.
LED on: The EL-Skyport wireless system is ready to use.
i
Frequency channel and Group settings must be identical between Transmitter and
Transceiver. Only the Elinchrom Skyport Transmitter is compatible.
In case of signal interference, try a different frequency.
Ready Charge BEEP (11)
The BEEP is active when the LED is illuminated.
1 x Beep:
3 x Beeps:
4 x Beeps:
Slow Charge (12)
The green LED indicates that the slow function is selected. The "Slow" mode increases the
number of flashes by approximately 40 %, from 110 in "Fast" recycle mode to 150 flashes.
The slow recycle mode also increases the battery life, but the recycling time is extended!
Auto-OFF (13)
This function, when active, shuts down the Ranger Quadra, when the unit is not in use.
The Timer can be individually programmed and is a useful feature to save Battery power.
Any re-use of the unit restarts the timer, before shutting down. 4 Beeps, if the function is
active indicate that the unit shuts down.
The unit is ready for operation.
The unit is overheated (or the charge circuit might be defective). The
display will show "Er1 ...4"
The Auto-OFF function is active and the unit shuts down or the Battery
charge level is too low.
EN
10