Elinchrom Ranger Quadra AS Manuel D'utilisation page 10

Synchronisation with Sync Cable (20)
For synchronisation use the included Sync cable 11088. Connect this cable with the 3.5 mm
jack socket of the unit and the PC plug with the camera PC contact. Remove the
rubber security cover before use. The Sync voltage is reduced to 5 V to protect your
Camera electronics.
Digital Power Display (16)
The actual flash power is shown in an f-stop compatible format, or can be changed to Ws.
P 6.0
This feature is active when the "Ws" LED is illuminated. In the „Ws" mode the display shows
400 8.2 Ws minimum and 400 Ws maximum power.
In the f-stop compatible format the steps can be programmed from 1/10th - 5/10th or in
1 f-stop steps.
The micro electronic controls all power changes precisely. The display shows power settings
from minimum 0.4 to maximum 6.0 power. The total power range is 6.6 f-stops.
During charging or discharging the display "flashes". In case of overheating or malfunction
the display shows "ErX", whereby X stands for the fault number 1-4.
Battery Status Indicator (14)
The green LED's indicate the actual Battery charge status. At full charge both LED's are
illuminated. At 50% charge, only one LED is illuminated. At approximately 10% charge the
LED starts flashing, with about 10 flashes at full power in fast recycle mode available before
the "Auto Battery Save" system shuts down the Ranger Quadra after 4 Beeps. The
"intelligent" electronics saves the battery from over discharging. With only 10% battery
charge, the units switches automatically into slow charge mode.
Menu / Setup (7)
This touch activates the Menu setup functions. After 2-5 s (see setup for "Auto Return")
if no other command has been applied the unit returns to normal mode and the display
shows the flash power setting. All changes are automatically stored.
Sub Menu (8)
The Sub Menu touch enables to the access additional features oft the main menu.
Photocell Status LED (9)
When switched on, the Ranger Quadra can be remotely triggered by another flash unit!
The Photocell is specially designed to work under ambient light situations, but direct sunlight
(or other direct strong lights) may reduce the sensitivity of the Photocell.
LED off:
LED on:
LED flashes:
Photocell is deactivated
Photocell is activated, the unit can be released remotely by another
flash unit.
The Photocell is in pre flash mode. This function enables to synchronise
cameras with the activated Anti-Red-Eye pre-flash function. Details
9