Glossary - Beyerdynamic MCS 50 Notice D'utilisation

6.9 Example for Configuration "Number of Stations" (MCS 50/64 only!)
In each line up to 32 stations can be connected to the control unit.
If for example 16 stations are to be connected in line 1 and 17 stations in line 2, you must do the following:
1. MCS Editor Software
Enter the number 64 into the field "Number of Stations". Now you have 64 stations to configure: 1 to 32 in line 1 and 33 to 64 in line 2 that
is the stations 1 to 16 in line 1 and the stations 33 to 50 in line 2 (corresponds to the 17 microphone units connected in line 2). A possible
chairman station in line 2, e.g. station no. 7 corresponds to station no. 40 in the MCS Editor. Save the configuration and download the file
into the Control Unit. The control unit is now looking for 64 stations, but there are only 33 connected.
2. MCS Control Unit
Close the MCS Editor Software or disconnect the PC from the control unit.
Start the configuration with the multi-function buttons and LC-Display.
Enter the number of stations into the configuration menu (in this example 33). Refer also to chapter "5.2 Configuration".
When the configuration is finished, the system works with 33 stations.
In the system check the control unit is looking for 33 stations and will find them.
7.

Glossary

Configuration
Manufacturer specific
User specific
Operation specific
NOM
Parameter
PTT
Reset
System Check
44
Adjustment of all parameters.
Parameters which have been set at the factory and which can be changed. Press the reset button (6)
to load these parameters.
Parameters which have been set from the user. Press the reset button (4) to load these parameters.
Adjusted parameters and their change to operate the system.
Number of Open Microphones which can be switched on simultaneously.
Adjustable values, e.g. Number of the connected microphones, operation mode, input level, output
level.
Push-To-Talk = adjustable operation mode for the microphone unit, where the microphone unit is
switched on as long as the microphone button of the microphone unit is pressed.
All parameters are reset to the original user or manufacturer specific configuration.
Automatic check of all system parameters which is carried out when the system is switched on.