Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5
If air is evacuated downwards, place the grease
filter into the ventilation element without the
positioning plate. It does not matter which way
round the grease filter is.
Pipe dimensions
Note: The manufacturer of the device accepts no
liability for claims caused by the piping.
▯
The device achieves optimum performance through
a short, straight ventilation pipe and the largest
possible pipe diameter.
▯
With long, coarse exhaust pipes and many pipe
bends, the optimum suction performance is not
achieved and fan noise becomes louder.
Connecting device
Connect the recess ventilation to the blower component
or the air circulation module using the 6-pin plug.
When the unit is used in conjunction with a inline
remote blower, the discharge air is to be directed to the
building exterior.
Connect Electrical Supply
9
WARNING
Risk of electric shock
Parts inside the appliance can have sharp edges.
The connection cable can be damaged. Do not
bend or pinch connection cables during
installation.
9
CAUTION
To reduce the risk of fire and electric shock,
install this appliance only with blower models
rated "maximum 7.5 A manufactured by
GAGGENAU".
Refer to data plate for more information. See "Service"
for data plate location.
The branch-circuit breakers ampacity, the wire sizes and
the connections must conform to the requirements of
the National Electrical Code or Canadian Electrical
Code and all local codes and ordinances.
This appliance is connected with a plug
▯
Plug has to be conform with NEMA
CONFIGURATIONS FOR PLUGS AND
RECEPTACLES.
▯
The appliance must be properly grounded.
▯
Plug must be rated not less than type 6-20 P
(2-pole 3-wire grounding).
▯
Only a qualified electrician should connect the
plug.
▯
Install a socket outlet earthed in accordance with
regulations approx. 27" (700 mm) above the floor
behind the appliance. The socket outlet must still
be accessible after installation.
11
Publicité
Table des Matières
