Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Prepare Installation Space
Create the cut-out in the countertop for one or several
Vario appliances according to the installation diagram.
The angle of of the cut surface to the countertop must
be 90°.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to
your countertop.
Observe minimum distance between appliance
underside and furniture parts of
When installing multiple Vario appliances:
account space requirement for VV 200 connection strip
between the appliances. Appliances can also be
installed in individual cut-outs, bearing in mind a
minimum distance between the appliances of 1
(40 mm).
8
/
" (10 mm).
3
8
Take into
/
"
9
16
Countertop Requirements
9
WARNING
To reduce the risk of ignition of surrounding
combustible materials, install at least 1¼"
(30 mm) from both sidewalls and at least 2"
(50 mm) from the rear wall.
The countertop must be level and horizontal. The
stability of the countertop must be maintained after the
cut-out has been made.
Publicité
Table des Matières
