Assembly Preparation; Assembly Instructions; Connecting The Wheel To The Support Leg - Pit Boss SPORTSMAN PB1230SP Guide De Montage

Parts are located throughout the shipping carton, including underneath the grill. Inspect the grill, parts, and hardware blister
pack after removing from the protective shipping carton. Discard all packaging materials from inside and outside of the grill
before assembly, then review and inspect all parts by referencing the parts list. If any part is missing or damaged, do not attempt
to assemble. Shipping damage is not covered under warranty. Contact your dealer or Pit Boss
through Sunday, 4am - 8pm PST (EN/FR/ES).
service@pitboss-grills.com | Toll-Free: 1-877-303-3134 | Toll-Free Fax: 1-877-303-3135
IMPORTANT: To ease installation and avoid injury, use two people when assembling this appliance.
Tools required for assembly: screwdriver and level. Tools not included.
IMPORTANT: It is advised to read each step entirely before starting assembly on instructions. Do not tighten screws
completely until all screws for that step have been installed. Hardware combination involving a locking washer and
washer should be installed with the locking washer closest to the head of the screw.

1. CONNECTING THE WHEEL TO THE SUPPORT LEG

Parts Required:
1 x Support Leg / Front (#17-1)
Support Leg / Back (#17-2)
1 x
Wheel (#16)
2 x
Wheel Cotter Pin (#E)
2 x
2 x Wheel Washer (#F)
2 x Wheel Axle Pin (#G)
Installation:
• Place a piece of cardboard on the floor to prevent scratching the unit and parts
during assembly. Attach the large Wheel to the Support Leg by inserting the
Wheel Axle Pin through the Wheel, Support Leg hole, then secure using the
Wheel Cotter Pin. Repeat installation for the other Wheel on same side.

ASSEMBLY PREPARATION

ASSEMBLY INSTRUCTIONS

Customer Service for parts: Monday
®
1
17-1
G G
F
16 16
E
17-2
F
E
5