Setting Up The Remote - Sony CDP-CX260 Mode D'emploi

Getting Started
If you have a Sony component with the CONTROL A1
jack
Connect the component via the CONTROL A1 jack. You
can simplify the operation of audio systems composed of
separate Sony components. For details, refer to the
supplementary "S-Link
System" instructions.
Setting the voltage selector (voltage
selector equipped models only)
Check that the voltage selector on the rear panel of the
player is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
before connecting the AC power cord to a wall outlet.
110 - 120 V
Connecting the AC power cord
Connect the AC power cord to a wall outlet.
Note on placement of the player and the
transmitter/receiver
Be sure to place the player in a flat, horizontal place.
If the player is left in a slanted position, it may cause a
malfunction or damage the player.
Be sure to place the transmitter/receiver on the top left
corner, facing forward, otherwise the player may not
operate correctly with the remote.
EN
6
TM
/CONTROL-A1 Control
220 - 240 V

Setting Up the Remote

This section describes how to prepare the supplied
remote for operation.
Press OPERATE on the transmitter/receiver to turn it
on and press I/u on the player to turn the player on.
If the following message appears in the remote's
display while setting up the remote, point the remote
at the player and the transmitter/receiver as illustrated
below.
C a n ' t r e c e i v e
P e l a s e t u r n
t h i s REMOT E
t o a ma i n u n i t
Note that the display disappears automatically if you
don't proceed for more than a few moments.
I/u
OPERATE
30°
PLAYER SELECT
MENU
RACK
MENU
Easy scroll
PUSH EN ER
key
CON INUE SHUFFLE
PROGRAM REPEA
MEMO SCAN DISC
SKIP
ME/ EX
BACK