7 Installation instructions
uw espressomachine
7.1 Important matters
•
After removing the packaging, make sure the product is complete and undamaged.
If in doubt, do not use the appliance and contact a qualifi ed professional.
Installation must be carried out by a qualifi ed techncian and in compliance with
•
current regulations.
Packing elements (plastic bags, polystyrene etc) must not be left within reach of
•
children as they may represent a hazard.
•
Never install the appliance in environments where the temperature may reach 0 °C or
lower (the appliance may be damaged if the water freezes).
Make sure the mains voltage corresponds to the voltage indicated on the appliance
•
rating plate. Connect the appliance to an effi ciently earthed socket with a minimum
current rating of 10 A only. The manufacturer may not be considered liable for
possible incidents caused by the failure to adequately earth the mains.
•
The power socket have to remain visible after installation.
Do not use multiple plug adapters or extension leads.
•
The power cable on this appliance must not be replaced by the user as this operation
•
requires the use of special tools. If the cable is damaged or requires replacing,
contact an authorised service centre only to avoid all risks.
For the electrical connection use a HO5 VV-F type cable as indicated in the table
•
below:
You should personalise water hardness as soon as possible following the instructions
•
in paragraph 4.2.6 on page 128.
Conductors
230 V ~+
~
Amount x size
2
3 x 1.0 mm
135