Use; Preparation - Pelgrim IKM540 Notice D'utilisation

3 Use

3.1 Preparation

Using for the fi rst time
The fi rst time you switch on the appliance and every time that it is plugged in, the
appliance makes a SELF-DIAGNOSIS operation when you press the main ON/OFF switch
(see A on page 106). Then the appliance switches off. To turn it on, press the on/off
button on the control panel.
1. The fi rst time you use the appliance, select the language. Press the main ON/OFF
switch on the right side of the appliance (see A on page 106); the lights on the front
side and the display go on. Wait for the appliance to display PRESS OK TO INSTALL
ENGLISH. Press the OK button for at least 3 seconds until the appliance displays
ENGLISH INSTALLED. The appliance then displays the setting message in English.
2. After a few seconds, the appliance displays FILL TANK.
To fi ll, remove the tank (fi g. 1), rinse and fi ll with fresh water.
Never exceed the MAX line. (When removing the tank, the
cappuccino maker must always be positioned outwards
(fi g. 2, position 1), otherwise the tank cannot be removed).
Put the tank back and push as far as it will go. Move the
cappuccino maker towards the centre of the appliance and
place a cup underneath it (fi g. 2, position 3).
Only fi ll the water tank with cold water. Never fi ll it with
other liquids such as mineral water or milk.
To ensure good, aromatic coffee at all times, you should:
- change the water in the water tank every day;
- clean the water tank with normal water for rinsing (not in
the dishwasher) at least once a week. Then rinse off with
fresh water.
1
3 2 1
2
111