Hitachi C 10FSH Instructions De Sécurité Et Mode D'emploi page 21

CAUTION:
* When cutting a workpiece of 3-11/32" (85mm) height, adjust the lower limit position
of the motor head so that the gap between the lower edge of the motor head and
the workpiece will be 3/32" to 1/8" (2 to 3mm) at the lower limit position.
* If the handle is pressed down with excessive or lateral force, the saw blade may
vibrate during the cutting operation and cause unwanted cutting marks on the
workpiece, thus reducing the quality of the cut.
Accordingly, press the handle down gently and carefully.
* In slide cutting, gently push the handle back (rearwards) in a single, smooth
operation.
Stopping the handle movement during the cut will cause unwanted cutting marks
on the workpiece.
WARNING:
* For slide cutting, follow the procedures indicated above in Fig. 30.
Forward slide cutting (toward the operator) is very dangerous because the saw
blade could kick upward from the workpiece. Therefore, always slide the handle
away from the operator.
* Always return the carriage to the full rear position after each crosscut operation in
order to reduce the risk of injury.
* Never put your hand on the side handle during the cutting operation because the
saw blade comes close to the side handle when the motor head is lowered.
7. Bevel cutting procedures
Holder (A)
Fixing pin
Bevel Scale
Indicator
(for left bevel scale)
Fig. 31
(3) Follow the procedures indicated in paragraphs 4,5 and 6 above. For maximum dimensions for bevel
cutting, refer to "SPECIFICATIONS" table on page 9.
WARNING:
When the workpiece is secured on the left or right side of the blade, the short cut-off
portion will come to rest on the right or left side of the saw blade. Always turn the
power off and let the saw blade stop completely before raising the handle from the
workpiece.
If the handle is raised while the saw blade is still rotating, the cut-off piece may
become jammed against the saw blade causing fragments to scatter about
dangerously.
When stopping the bevel cutting operation halfway, start cutting after pulling back
the motor head to the initial position.
Starting from halfway, without pulling back, causes the safety cover to be caught in
the cutting groove of the workpiece and to contact the saw blade.
CAUTION:
When cutting a workpiece of 2-3/8" (60mm) height in the left 45° bevel cutting position
or a workpiece of 1-3/8" (35mm) height in the right 45° bevel cutting position, adjust
the lower limit position of the motor head so that the gap between the lower edge of
the motor head and the workpiece will be 5/64" to 1/8" (2 to 3mm) at the lower limit
position (refer to "3. Checking the saw blade lower limit position" on page 13).
(1) Loosen the clamp lever and bevel the saw blade to the left or to
Clamp Lever
the right.
When tilting the motor head to the right pull the fixing pin
towards the rear.
The clamp lever adopts a latchet system. When contacting the
work bench and the main body, pull the clamp lever in the
direction of the arrow mark as illustrated in Fig. 31, and change
the direction of the clamp lever.
(2) Adjust the bevel angle to the desired setting while watching
the bevel angle scale and indicator, then secure the clamp lever.
Tighten
Pull
Loosen
English
21