Cable Routing; Factory Settings - Siemens SIMOTICS M-1PH8 Série Instructions De Service / Instruction De Montage

K3G280-RR03-H4
Siemens AG DI MC + LD

4.3.3 Cable routing

Water must be prevented from reaching the cable gland along the cable.
NOTE
Damage caused by moisture penetration.
Moisture can penetrate into the terminal box if water is
constantly present at the cable glands.
→ To prevent the constant accumulation of water at the cable
glands, the cable should be routed in a U-shaped loop
wherever possible.
→ If this is not possible, a drip edge can be produced by
fitting a cable tie directly in front of the cable gland for example.
When routing the cable, make sure that the cable glands are located at
the bottom. The cables must always be routed downward.

4.4 Factory settings

Factory settings made for the device by ebm-papst.
Mode parameter set 1 PWM control
Mode parameter set 2 PWM control
Fan/device address
01
Max. PWM / % 100
Min. PWM / % 10
Save set value to No
EEPROM
Set value requirement Analog (linear)
Direction of action Positive (heating)
parameter set 1
Direction of action Positive (heating)
parameter set 2
222
Item no. 55768-5-9970 · ENU · Change 211390 · Approved 2020-01-17 · Page 8 / 13
ebm-papst Mulfingen GmbH & Co. KG · Bachmühle 2 · D-74673 Mulfingen · Phone +49 (0) 7938 81-0 · Fax +49 (0) 7938 81-110 · info1@de.ebmpapst.com · www.ebmpapst.com
Operating instructions