Table Des Matières - LEGRAND KEOR T EVO 10 KVA Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Description of the Symbols Used in the Manual
1.1.
1.2.
Manuel
This symbol points out the instructions which are especially important.
2.1.
Conditions de la garantie
2.2.
importantes.
This symbol points out the risk of electric shock if the following instruction is
3.1.
Description des symboles utilisés sur les étiquettes apposées sur l'ASI
not followed.
3.2.
Équipement de protection individuelle
3.3.
3.4.
3.5.
This symbol points out the instructions, which may result with injury of the
operator or damage of the equipment if not followed.
4.1.
Ce symbole attire l'attention sur des instructions qui, si elles ne sont pas suivies,
4.2.
risquent de provoquer des blessures chez l'opérateur ou un endommagement de
4.3.
Mode By-pass
All packing material must be recycled in compliance with the laws in force in the
l'équipement.
4.4.
country where the system is installed.
4.5.
4.6.
4.7.
Fonctionnement avec le by-pass de maintenance externe (en option)
Tout le matériel d'emballage doit être recyclé conformément à la législation en
vigueur dans le pays où le système est installé.
5.1.
Transport
5.2.
5.3.
5.4.
ASI : Alimentations sans Interruption
RS232: Serial Communication Protocol
6.1.
Modèles et dimensions
6.2.
ESD : Dispositif de coupure d'urgence (Emergency Switching Device)
RS485: Serial Communication Protocol
6.3.
Procédures et instructions d'installation
RS232 : Protocole de communication série
6.3.1.
Raccordement de l'alimentation des systèmes unitaires
MODBUS: Modicon Communication Protocol
6.3.1.1.
Connexion à la terre
6.3.1.2.
Connexion au secteur (redresseur)
6.3.1.3.
Connexion à l'alimentation auxiliaire
V: Volt
6.3.1.4.
Connexion à la batterie
6.3.1.5.
A: Ampere
6.3.1.6.
P: Power
6.3.1.7.
Connexion au by-pass de maintenance externe
A : Ampère
6.3.1.9.Protection contre le retour de tension pour une double entrée d'alimentation
P : Puissance
For Mains Supply, Auxiliary Mains Supply, Output, Battery Circuit Breaker and Maintenance Bypass Circuit
6.3.2.
Breaker;
7. INTERFACE HOMME-MACHINE
"ON": Closing the Circuit
by-pass de maintenance ;
7.1.
7.1.1.
7.1.2.
Barre de LED d'état de l'ASI
OFF (Arrêt) : Ouverture du circuit
7.2.
7.2.1.
7.2.2.
7.2.3.
7.2.4.
7.2.5.
7.2.6.
KEOR T EVO
KEOR T EVO
KEOR T EVO
3
3
3
5
5
5
6
6
6
7
8
8
9
9
10
11
12
12
12
12
13
13
13
15
15
18
18
19
20
21
29
29
30
31
39
40
41
41
42
44
45
45
46
48
49
49
50
51
54
56
56
1
1

Publicité

Table des Matières
loading

Table des Matières