Hitachi CR 18DL Mode D'emploi page 17

2. Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 6. Make sure it contacts the
bottom of the battery charger.
3. Charging
When the battery is connected to the battery charger, charging will commence and the
pilot lamp will light in red. (See Table 4)
NOTE: If the pilot lamp does not light or blink in red, pull out the plug from the receptacle
and check if the battery is properly mounted.
When the battery is fully charged, the pilot lamp will blink in red slowly. (At 1-second
intervals) (See Table 4)
WARNING:
Do not use the electrical cord if damaged. Have it
repaired immediately.
Fig. 6
Pilot lamp
English
17