Control Settings; Temperature Controls - GE 18 Série Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

About the controls on the refrigerator.
The temperature controls on your refrigerator have letters
and numbers. Initially set the fresh food control at 5 and
the freezer control at C.
5 INITIAL SETTING
5
9 COLDEST
FRESH FOOD

Control Settings

Fresh Food Control
The fresh food control maintains the temperatures throughout the refrigerator.
Moving the fresh food control to OFF stops cooling in both areas—fresh food and freezer—but does
not shut off power to the refrigerator.
Freezer Control
The freezer control moves a damper to change the amount of cold air that moves from the freezer
to the fresh food compartment.
How To Test Temperatures
Use the milk test for the fresh food compartment. Place a container of milk on the top shelf and check
it a day later. If the milk is too warm or too cold, adjust the temperature controls.
Use the ice cream test for the freezer compartment. Place a container of ice cream in the center of the
freezer and check it after a day. If it's too hard or too soft, adjust the temperature controls.
After changing the controls, allow 24 hours for the refrigerator to reach the temperature you have set.
Power Saver Switch
Push switch to the POWER SAVER setting to reduce the amount of electricity required to operate
your refrigerator.
With this switch turned to the POWER SAVER setting, moisture may form on the outside of the
refrigerator, especially when the weather is humid.
Over time, moisture that forms on the surface may cause rust.
To prevent moisture on the outside, move the power saver switch from the POWER SAVER setting.
Cost? About the same as it costs to use 2 night lights.
If you want colder or warmer temperatures, adjust the
fresh food temperature first. When satisfied with that
setting, adjust the freezer temperature.
Damper
E
D
INITIAL SETTING C
C
COLDEST E
B
FREEZER
A
E
Cold air
C
from freezer
compartment
A
(Warmest
setting)
Side View
(Coldest
setting)
Damper
5

Publicité

Table des Matières
loading

Table des Matières