Setting Down, Transportation And Storage; Maintenance - Miele Complete C3 Mode D'emploi

en

The Standby button is designed
to pause the vacuum cleaner for
short periods of time whilst vacuum‐
ing. Do not leave the vacuum cleaner
in Standby mode for long periods.
Otherwise there is a risk of overheat‐
ing and damage.
An LED will indicate each time a button
is pressed on the handle.
At the end of the pause you can do one
of the following:
 Press the Standby button  again to
switch the vacuum cleaner back on
at the setting you were using before
pausing it.
 Press the + button to switch the va‐
cuum cleaner back on using the hig‐
hest power setting.
 Press the - button to switch the vacu‐
um cleaner back on using the lowest
power setting.
Setting down, transportation
and storage
Park system for pauses during vac‐
uuming (dia. 29)
The Park system allows you to conven‐
iently park the suction tube and floor‐
head during pauses.
 Slot the floorhead into the parking at‐
tachment at the back of the vacuum
cleaner.
If your vacuum cleaner is on a slop‐
ing surface, e.g. a ramp, retract the
telescopic tube fully.
44
Switching on and off with the Park
system
Some models are fitted with an On/Off
switch in the Park system.
The vacuum cleaner switches off auto‐
matically when the floorhead is slotted
into the parking attachment. When the
floorhead is removed from the parking
attachment, the vacuum cleaner
switches back on at the previously se‐
lected power level.
Park system for storage (dia. 30)

Always disconnect the vacuum
cleaner from the electrical supply
when you have finished using it.
Switch it off at the wall socket and
unplug it.
 Stand the vacuum cleaner upright.
Retract the telescopic tube fully so
that the vacuum cleaner takes up less
room for storage.
 Slot the floorhead downwards into
one of the parking attachments on
the sides of the vacuum cleaner.
This makes the vacuum cleaner easier
to carry or store.

Maintenance


Always disconnect the vacuum
cleaner from the electrical supply for
maintenance work and for cleaning.
Switch off at the wall socket and un‐
plug it.
The Miele filtration system consists of
three components: